Pump for Reverse Osmosis Filters 24V for 3/8″ Tube

Instructions for use:

• To operate the device, you must use the appropriate power adapter.
• It is strictly forbidden to use the pump directly through the raw water without pre-filtering, otherwise it will affect the effect and service life.
• The pumps are not available in corrosive liquids, alcohols, acid-alkaline liquids, etc.
• The wiring is not divided into positive and negative poles, and the two wires can be connected at will.
• When installing inside the water purifier, tighten the screws to avoid resonance noise and try to keep enough space for the pump to dissipate heat.
• The pump should not run continuously for more than 4 hours. Stop for 30 minutes for more than 4 hours.
• The pump is not available for irrigation, solar, swimming or water heater compression.

Technical information:

• Model: wf-pu-24v
• Working voltage: 24V
• Inlet pressure: 0 psi
• Working pressure: 80 psi
• Working current: ≤1.2A
• Working flow rate: ≥55LPH
• Maximum current: ≤2.8A
• Maximum pressure: ≤80psi
• Size (Length * Width * Height): 186*100*102